|
The SKATER Junior can be equipped with
a wide range of smaller camera heads from
manufactures such as Cartoni, Sachtler, OConnor,
Manfrotto, Silk and others or with photo heads, like three way
heads, ball heads etc with a 3/8“ or 1/4“ mounting screw. To
maintain a low lens position, these camera heads should have
a flat base or a removable bowl.
Engravings on the bottom side of the base plate indicate
several sets of mounting holes for different manufactures.
The new patented adjustable wheel shows detailled scales
in metric and imperial which allows to directly determine
the radius for a rotation tracking shot. No other adjustment
is required. To execute linear tracking shots the adjustable
wheel is set to a parallel position within seconds.
Of course rotating shots can also be set up with a laser pointer
which is identical to the one used on the SKATER® Mini. A wide
range of additional accessories from the SKATER® Mini can be
used on the Junior as well (see below). |
|
|
| Selection of suitable camera heads for SKATER® Junior
(must show a flat mounting base) |
| - Cartoni - Action Pro (bowl needs to be taken off) |
| - Sachtler - FSB 2, FSB 6, DV6 SB to DV12 SB, Video 15 SB
(requires newer models with integrated flat base fitting) |
| - OConnor - 1030 HD |
| - Manfrotto - 128 LP or RC, 501 HDV, 503 HDV, 516, 700RC2,
701RC2 |
| - Photo heads: three way heads, ball heads, panoramic heads
or geared heads with 3/8“ or 1/4“ mounting screw |
|
|
|
|
|
|
|
|
|
|
|
 |
Accessories |
|
| The following SKATER® Mini accessories can be used with the
SKATER® Junior: |
| - SKATER® Laser Pointer |
| - SKATER® Levelling Support |
| - Holder
for SKATER® motor |
| - SKATER® Smooth Gear Module |
| - SKATER®
Control |
| - SKATER® Motor |
| |
|
 |
23221 |
SKATER Junior camera dolly
|
|
|
 |
20803 |
SKATER Laserpointer |
|
|
 |
21035 |
SKATER Levelling support
width 40 cm / 15,7“, 28mm-pin
incl. set of 2 guidance rings
(wooden board not included) |
|
|
 |
21258 |
Holder for SKATER motor
or third-party motor or
smooth gear module |
|
|
 |
21636 |
SKATER Mini Smooth Gear Module
(Note: motor holder # 21258 necessary) |
|
| |
|
|
SKATER Control, SKATER Motor and power cables can also be used with the SKATER Junior, please refer to chapter `SKATER Control` for more details. |
|
